Skip to content

Information on gate operation installation sourcing troubleshooting

Answers to Frequent Questions

At Electronic Entry Systems, we understand that choosing the right security solution can raise a lot of questions. Our FAQ page is here to provide clear, helpful answers to some of the most common inquiries we receive about our automatic gates, access control systems, and security solutions. Whether you’re curious about installation, maintenance, or customization options, we’re here to guide you through the process. If you don’t see the information you’re looking for, feel free to reach out—we’re always happy to assist!

Which way do swing gates swing, in or out?

The gates usually swing in, but in some cases, due to limited space, traffic flow, or uphill driveways, the gates may have to swing out, which would result in outside mounted or outside swinging gate operators.

How are gate and fence posts installed and how deep do you install concrete pads?
All gate and fence posts are installed in concrete footings and ground mounted operators and pedestals are mounted on concrete pads, all of which are installed deep to get below the frost line. Concrete or asphalt surfaces require coring through the surface in order to set the posts or pads.
Are permits required and who is responsible for them?

If any permits are required, they should be obtained by the customer, as they are not included in our contract. Check with your city for your local codes.

Where do the gates come from?
We have professional fabricators that have been making gates for our automatic equipment for over thirty years. Most of our gates are custom fabricated and can be made to match almost any existing gate, fence, or railing. Almost all varieties of our iron and steel work is powder coated. The powder is sprayed on dry, then sent through a giant oven, which bakes it on at extremely high temperatures, resulting in a much longer life than traditional priming and painting. If you see a gate or fence you like, send us a link to it, write down the address, or take a picture of it, and we can match it.
If the gate operator isn’t opening automatically, how do I get through?

There is a manual release key, lever, or other mechanism, which disengages the motor so you can operate the gate manually. Also, we can provide BBU (Battery-Back-Up) power systems, which will allow the gates to be opened in case of power outage.

How does my postal carrier get through the gates?
You may have to put your mailbox outside of the gate, or you can set up an open schedule for the estimated time of mail delivery. Otherwise, if you plan on keeping your gates open during the day, they will be open for the delivery. In some cases, they may only require a postal key switch or a keypad code, both of which we can provide.